FK 1000 P

Wax in a paste for high temperature, polyester, vinylated and epoxy. High shine.

Resistance 200°C

Cirex Si 019

Remover cleaning agent for effectively removing wax and resin residue, without impacting the gelcoat of the mould quality.

Cirex Si 021

Renovating and reinforcing sealer.

Cirex Si 022

Sealer of micro porosity and primer for semi-permanent release agents.

Increases the lifetime of the mould.

Cirex Si 023

Micro porosity sealer and primer for semi-permanent release agent. Reinforced primer for any liquid and paste agent. Strongly recommended for the use of CIREX Si 60, 66, 68 and 34.

Improved resistance to trampling. Increases the lifetime of the mould.

Cirex Si 034

New semi-permanent solvent for polyester resin. High performance / application by smooth cloth. Does not cause fisheyes or self-releasing.

Use up to 180°C

Cirex Si Bouchpor W1

Water based pore filler agent. Holding up to 420°C

Can be used with CIREX Si 40 WB and Si 041 WB

Cirex Si 039 WB

Water based release agent for epoxy, vinylester and polyester.
Stable at high temperature 400°C.

Reduce the problems of auto-release. Compatible with lacquered type PU or solvent-based EP. Buffing easier than with Cirex Si 041 WB.
On micro porous support, Apply Cirex Si Bouchpor W1

Cirex Si 40 WBN

Water based release agent for epoxy, vinyl ester and polyester.

Holding up to 250 ° C. Avoids problems of self-releasing and fisheyes.

Can be used if necessary with the CIREX Si Bouchpor W1

Cirex Si 041 WB

Water based release agent for epoxy, PEEK, PEI, vinyl ester, polyester, Elastomers and PU foams. Holding 420 ° C.

Can be used if necessary with the CIREX Si Bouchpor W1

Cirex Si 042 NC

Semi-permanent solvent base for epoxy, vinyl ester and polyester. Holding 390 ° C. High yield on composite and metal moulds. High gloss.

Can be used if necessary with sealer CIREX Si 022 or Si 023

Cirex Si 043

Semi-permanent solvent base for epoxy, vinyl ester, polyester and phenolic. Significant slippery effect. High yield on composite and metal moulds.

Can be used if necessary with sealer CIREX Si 022 or Si 23

Cirex Si 60

Milky white solvent base release agent. Effective with epoxy, vinyl ester and polyester.

Holding temperature 180 ° C. Avoids problems of self-releasing and fisheyes. For use with CIREX Si 023 to avoid any risk of gripping. This release agent is compatible with traditional waxes.

Cirex Si 73

Water based release agent formulated for mandrain release.

Allows the release of polyester, epoxy and Phenolic. Holding 200°C

Cirex Si 111

Release agent in a thixotropic paste.

Ideal for quick modelling on technical layers, tools RTM or all porous substrates.